ABS plastic - the same as telephones.
High density polyethylene, approximately one (1) mili (one-thousandth of an inch).
Yes. All Sani Seats installed in the USA are warrantied for life excluding damage caused by obvious customer abuse and/or vandalism. * Warranty valid in USA only and other restrictions may apply. Please call your local dealer for their warranty information and details.
The amount of Sani Wrap used is totally dependent on the amount of traffic in the establishment in which it is installed.
Approximately 1,500 seatings of sanitary seat covers and take-up spools.
12 volt rechargeable battery packs and/or 12 volt transformers.
Thread the Sani Wrap under and around the take-up spool, turning the spool toward you several revolutions.
The blade splits the Sani Wrap allowing it to pass between the seat "attachment plate" and around the take-up spools thus preventing reuse.
No. It's completely concealed when the housing is in place.
Depending on the amount of traffic, approximately every six months.
There is a tray located on the bottom side of the Sani Seat which allows any excess liquid to drain through the hole at the base of the tray, directly into the bowl.
Yes. Sani Seat fits all standard toilets and is installed in the same way as a conventional seat. Standard fittings are included in each carton.
Yes. It functions exactly the same way.
By following the instructions supplied with the Sani Seat, most technical problems can be easily solved. If the problem is more difficult and not able to be resolved by your maintenance personnel, call the service representative.
No. It's in the form of a sleeve which fully encases the seat.
Sanitary Prevention Service
20 to 30 seconds.
Sani Seat can be used as a regular toilet seat until the Sani Seat unit is repaired and/or a new roll of Sani Wrap is installed.
Through training by our staff and by following the instructions in the Operations Manual.
Simply wave your hand over the sensor to feed the remainder of the Sani Wrap sleeve, then reload the roll.
The chances of that are greatly reduced with Sani Seat because people will no longer hesitate to sit directly on the seat. If this should happen, however, clean the Sani Seat like any other conventional toilet seat.
To clean the Sani Seat, use a sponge or hand-towel dampened with household sanitizers, i.e., Lysol or Pine-Sol cleaner.
This will create undesirable friction. Remove Sani Wrap from seat, clean and dry seat completely, and then refeed the remaining roll of Sani Wrap.
The LED display will indicate how many seat covers are remaining on the roll.
Simply remove the cover and clean the housing using a household sanitizer.
Yes. If a strong acid is continually used, it will harm the plastic surface.We have personnel available for the continuous cleaning of our restrooms.
With Sani Seat the amount of personnel required to maintain restrooms can be drastically reduced, or their priorities can be redirected to perform other duties. Even in those restrooms that have a fulltime attendant, no one can guarantee a clean, sanitary seat every time. Now with Sani-Seat it is possible... simply by waving your hand.
No, for the following reasons: the used sleeve is wound up in a roll and any germs are confined in that roll. The used roll of Sani Wrap is enclosed in a separate, isolated chamber, to prevent the germs from migrating onto the seat and/or to the fresh roll of Sani Wrap.
Yes. We have very strong patents including the United States and Canada!
Sani Wrap is manufactured and packaged in a sterile environment. Sani-Seat is assembled in our clean, modern facility. When put into use together they provide a sanitized, uncontaminated surface for each user.
Plastic Parts are made in China and Critical Electronics are Made in America with all final assembly and testing is done in our New Jersey Facility!